. Operazioni dell'Istituto degli ingegneri minerari . -ferro, ghisa grigia, ghisa malleabile, acciaio fuso ad alto tenore di carbonio e getti non ferrosi come alluminio, bronzo, ecc. le condizioni sopra elencate sono soddisfatte con successo da un generatore a bassa tensione composto piatto speciale, che alimenta il circuito mediante un controllore a corrente costante sotto forma di resistenza azionata da solenoide. Questo solenoide è in serie con l'arco, il corrente attraverso l'arco essendo controllato dalla variazione automatica di una variabileistanza in risposta alla trazione del solenoide, che comprime orre

• Collaboratore: Reading Room 2020 / Alamy Foto Stock
• ID dell’immagine: 2CH86XB
• Dimensioni dei file: 7,2 MB (512,9 KB Download compresso)
• Liberatorie: Modello - no | Proprietà - no
• Dimensioni: 1944 x 1286 px | 32,9 x 21,8 cm | 13 x 8,6 inches | 150dpi

Altre informazioni

Questa foto è un'immagine di pubblico dominio, il che significa che il copyright è scaduto o che il titolare del copyright ha rinunciato a tale diritto. Alamy addebita un costo per l'accesso alla copia ad alta risoluzione dell'immagine.

Questa immagine potrebbe avere delle imperfezioni perché è storica o di reportage.

. Transactions of the Institution of Mining Engineers . -iron, grey cast-iron, malleable cast-iron, high-carbon cast-steel, and non-ferrous castings such as aluminium, bronze, etc. The conditions enumerated above are successfully fulfilled by meansof a special flat compound low-voltage generator, which feeds thecircuit through a constant-current controller in the form of a solenoid-operated resistance. This solenoid is in series with the arc, the currentthrough the arc being controlled by automatic variation of a variableresistance in response to the pull of the solenoid, which compresses orrelaxes a series of copper and carbon plates. The ordinary carbonresistance can be used, but is not successful, since the plates becomevery dirty, thereby causing excessive heating. There is, in addition, a pilot motor, which is operated by a switchat the welding-tool handle, by which a further adjustment in resistancecan be made, so regulating the amperage that the operator can changethe arc current without leaving his work. This is very essential when. Fig. 1.—RoBEY Compound Set and Flywheel in Gutted Power-house.The Six Cracks can just be discerned on the Face of the Wheel, AS indicated by the Arrows. building up a large patch, as the heat increases with the deposition ofthe metal, owing to the path of the current lying through the deposit;and as it is essential, in order to ensure a successful patch, that thetemperature of the deposit should be kept as low as possible compatiblewith complete fusion, a gradual reduction of arc current is necessary.This is known as the Wilson system, or constant-potential type, in whichan open-circuit voltage, not exceeding 35 volts, is used. Inasmuch asthe current control is automatic, it differs in this respect from— (1) The drooping characteristic type, with a voltage of from 60 to75 and a current varying in inverse ratio to the voltage; and (2) The constant-potential type, with a voltage also of from 60 to75, but with the current control

Parole chiave associate all'immagine

• bo
• bookcentury1800
• bookdecade1890
• booksubjectmineralindustries